Can-Am Maverick VIN Number Location – Full Guide

Under or Behind the Passenger Seat

On most Can-Am Maverick models, the VIN is located under or directly behind the passenger seat. This is one of the most reliable places to find the Can-Am Maverick VIN number location, especially on stock machines with the original frame.

The VIN is stamped into the metal frame, not printed on a sticker. In most cases, it sits on the frame rail beneath the passenger seat base. If it is not immediately visible there, it is often stamped just behind the seat mounts, along the same frame section on the inner side.

To access it, slide the passenger seat fully forward and then fully backward. This gives a clear view of the frame area beneath and behind the seat. A flashlight helps, as the stamped characters can be shallow and hard to see at first glance.

Off-road use often covers this area with mud, dust, or grease. Cleaning the frame surface is usually required before the VIN becomes readable. Once clean, the full VIN should be visible as a permanent stamping in the metal.

Front Frame Near the Passenger Front Wheel

Another common Can-Am Maverick VIN number location is on the front frame, close to the passenger-side front wheel. This placement is typical on several Maverick trims, especially where the front suspension and frame rails meet.

The VIN is stamped directly into the metal frame rail. It is not attached to plastic panels or suspension parts. In most cases, the stamping sits low on the frame, near the wheel well opening, and faces inward toward the vehicle.

Access is usually gained through the passenger-side wheel well. Turning the front wheel outward creates more space to see the frame surface. On some models, you may need to crouch or look upward from a low angle to spot the stamping.

Because this area is exposed, road grime and mud build up quickly. The VIN can be completely hidden until the frame is cleaned. Once cleared, the stamped VIN should be clearly readable and match the number found under the passenger seat.

Underneath the Glove Box

On some Can-Am Maverick models, the VIN is located underneath the glove box area.
This location is more common on newer trims and updated dashboards.

The VIN is placed on a metal frame section behind the glove box, not on plastic.
It may appear as a stamped number or a fixed metal plate.

General Wheel-Well Locations

On some Can-Am Maverick models, the VIN can be found in the general wheel-well area, usually near the front wheels. This location is closely tied to the main frame structure and is used when space around the cabin or seat area is limited.

The VIN is stamped directly into the metal frame rail inside the wheel arch. It is never placed on plastic liners, fenders, or suspension components. Depending on the model year and trim, the stamping may run vertically or at a slight angle along the frame.

Accessing this area is easiest by turning the front wheels outward, which opens up the wheel well and improves visibility. In some cases, especially on machines with larger tires or aftermarket suspension, the frame may be partially obscured, requiring a closer look from a lower angle.

Because the wheel well is constantly exposed to mud, sand, and road debris, the VIN is often hidden beneath a layer of grime. Cleaning the frame surface is usually necessary before the numbers become readable. Once visible, the VIN in the wheel-well area should match the numbers found in other frame locations on the vehicle.